Passenger airbag on киа оптима

Kia Optima: Airbag Module / Passenger Airbag (PAB) Module

The passenger airbag (PAB) is installed inside the crash pad and protects the front passenger in the event of a frontal crash. The SRSCM determines if and when to deploy the PAB.

Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using a specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury.

Components and components location
Repair procedures

Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury.

Inspect the airbag according to troubleshooting table.

(Refer to Passenger Airbag Module — «Troubleshooting»)

Читайте также:  Электронный щиток приборов киа спектра

If the passenger airbag module has been deployed, replace the damaged crash pad.

Remove the main crash pad assembly.

(Refer to Body — «Main Crash Pad Assembly»)

Remove the passenger airbag module (A) after loosening the bolts.

3.9 — 5.8 N·m (0.4 — 0.6 kgf·m, 2.8 — 4.3 lb·ft, 34.7 — 52.0 lb·in)

Install in the reverse order of removal.

After installing the airbag module, confirm proper system operation:

Switch «ON» the ignition. The SRS indicator light should turn on for about six seconds and then off.

Troubleshooting
Driver Airbag (DAB) Module and Clock Spring

Description and operation Description The Driver Airbag (DAB) is installed in the steering wheel and electrically connected to SRSCM via the clock spring. It protects the driver by dep .

Side Airbag (SAB) Module

Description and operation Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when a side crash occurs. The SRSCM d .

Other information:

Kia Optima DL3 2019-2023 Service and Repair Manual: Piston and Connecting Rod

Components and components location Components 1. Piston ring 2. Snap ring 3. Piston pin 4. Piston 5. Connecting rod 6. Connecting rod upper bearing 7. Connecting rod lower bearing 8. Connecting rod bearing cap Repair procedures .

Kia Optima DL3 2019-2023 Service and Repair Manual: Rear Door Inside Handle

Repair procedures Replacement 1. Remove the rear door trim. (Refer to Rear Door — «Rear Door Trim») 2. Loosen the mounting screws and remove the rear door inside handle (A). 3. Install in the reverse or .

Источник

Тема: Загорелась лампа подушки безопасности пассажира

Valerun

  • Просмотр профиля
  • Сообщения форума
  • Личное сообщение
  • View Gallery Uploads

Valerun вне форума

Оптимист ( 9290 )

185 24

Загорелась лампа подушки безопасности пассажира

Не нашел тем про пассажирскую подушку.
Проехал по трассе 150 км с разной скоростью, ям не ловил, ударов не было, жена рядом пристегнута — все ОК. Выпили, поздравили, поспали, поели. ))) Машина стояла во дворе на участке рядом с домом. Обратно поехали — загорелась лампочка на приборке — подушка пассажира отключена. Пробовал заглушить-запустить не помогло, так и вернулись. В гараже попробовал справа на торпеде ключом выключить-включить. ремень пощелкал. не помогло.
При запуске лампочка загорается, потом гаснет и через несколько секунд снова загорается и горит постоянно.
Кто-нибудь с таким сталкивался?
Позвонил ОД сказали надо подъехать, записался на 13, а до этого получается (по инструкции) никого и возить нельзя на пассажирском, только суицидников )))

tre-vladimir

  • Просмотр профиля
  • Сообщения форума
  • Личное сообщение
  • View Gallery Uploads

tre-vladimir вне форума

155 14

Источник

Kia Optima Airbag Light: Meaning + How to Fix

Drivetrain Resource

When you start your Kia Optima, the airbag module runs a self-diagnostic check on all its major systems. If any of these checks fail, you will see an airbag warning light on the dashboard.

Depending on the model year and what country you happen to be in, you may get something along the lines of SRS, a picture of a person with the airbag deployed, or the word airbag. All of these should be treated as the airbag light.

Kia Optima Airbag Warning Light Repair

The number one reason that an ABS System fails is problems with the belt and seat sensors.

How the Airbag System Works

How airbags work

Airbag System Components

Here are the main components of your Kia Optima’s airbag system and how they work.

  • Passenger Airbag Switch– Some vehicles are equipped with a manual airbag switch for the passenger seat that can be turned on and off with the key. Most have a sensor under the front seat that weighs the occupant. If they aren’t heavy enough, the passenger airbag will not deploy in a collision.
  • Clock Spring– The clock spring is a coil inside the steering wheel that connects the electrical components of the steering wheel to the rest of the vehicle (including the airbag).
  • Airbag– Your car’s airbag is released by a chemical explosion. It can inflate the bag in 30ms. Here’s a detailed video on how an airbag system works.
  • Sensors- Your Optima’s airbag module takes data from the wheel speed sensors, brake pressure sensor, seat pressure sensors, seat buckle sensors, gyroscopes, and a sensor that tries to detect if you’re in a crash (often referred to as the MEMS sensor).

How it Uses These Components

The airbag control module will use the data from the sensors listed above to deploy the airbags when necessary.

Airbag Light Diagnosis

Airbag Light Fix

The airbag light comes on because your Kia Optima’s airbag control module has failed a self-diagnostic cycle, which means there will be codes stored that’ll tell you why the light came on.

The catch is not every OBD II scanner can pull airbag-related codes. So you’ll either have to take your Optima to a shop to have them read or pick up a quality scanner.

Here’s a great five-minute video showing how to pull the codes and diagnose the airbag light.

Airbag Light most common fixes

Safety belts are still the most critical safety feature in the event your Optima crashes. Modern vehicles have sensors running to the seat belts to let the computer system know if they are buckled and locked up.

If you have a seat belt stuck in the lock position, it might be why your airbag light is on. See if you can tug at it and get it moving.

With your Optima’s engine running and in park, sit in each seat and buckle the belt. If one of the sensors doesn’t tell you that a seat belt has been unbuckled when you get up, that’s likely your culprit.

2. Seat Sensors

Kia Optima Airbag Light Causes

The wiring harness under the front seats shorting out is perhaps the most common reason the airbag light comes on.

If the seatbelt light doesn’t come on when someone isn’t wearing a belt in the front, it’s either the wiring harness under the seat or the seatbelt sensor that is at fault.

The seat sensors tell the airbag system that the seat is occupied. Some older vehicles have a manual button to turn the passenger airbag on or off.

Look under the seats to see if you can find any part of the wiring harness that has come dislodged or damaged. This is a very common reason why the airbag light comes on.

3. Clock Spring

The clock spring connects your Optima’s steering wheel controls, horn, and airbag to the rest of the car. When it fails, the airbag light will come on.

4. Airbag Failure

If your Optima’s airbag system is not getting a response from one of the airbags in the diagnostic cycle, it’ll turn the airbag light on until the problem has been fixed and the system has been reset.

5. Airbag Module /Sensors

Your Optima’s airbag system control unit may have failed. If this is the case, you can have it replaced or send for a new one. This often happens whenever you get into a fender bender that doesn’t deploy the airbag.

One or more crash sensors may have been triggered, but not enough to deploy the airbag. The airbag sensors can also fail and throw the airbag light on if there is water damage. This is one of the reasons why it is not wise to buy a car with flood damage, even if it looks like it is otherwise fine.

6. Not Reset After Deployment

If your Optima’s airbag has gone off and been replaced, the airbag system needs to be reset. It won’t work until the airbag system has been reset or you send the module to someone who can do it for you.

Frequently Asked Questions

How Do You Reset The Kia Optima’s Airbag Light?

You can reset it by fixing the fault in the airbag system. After that, your car’s airbag light should turn itself off.

Is it Safe to Drive Your Optima with the Airbag Warning Light On?

It is not as safe to drive with the airbag light on. Airbags have saved countless lives since their invention. If you drive with your Optima’s airbag light on, you are relying solely on the seat belts to keep you safe, which carries a higher risk of serious injury.

What Does the Airbag Light Mean?

The airbag light indicates that at least one component of your Optima’s airbag system has failed a self-diagnostic cycle, and the airbags will not deploy in the event of a collision.

Conclusion

Your Kia Optima’s airbag system is complicated. There can be a lot of different reasons why the airbag light may have come on. Most of them should be left to a professional.

RECALLS! January 2022 Jason, “MAZDA6 shuts down while driving” fuel pump not monitored, may be no engine light etc. SEE…

I have a 2007 h3 hummer base model. Had transmission rebuilt (Pro).My problem is that when it gets around 35…

Источник

Оцените статью